Target Trigger Precision from a GI-Style Configuration

The FM-9 GI Style AR-15 Trigger Group from FM Products couples the simplicity and reliability of the standard military M16 / M4 trigger with enhancements that give you a smoother, more consistent pull, cleaner release, and less pre-travel. Each FM-9 trigger is precision machined from A2 tool steel – no MIM parts here! – then micro polished to eliminate grittiness or “creep” during the pull.

Finally, the hammer and trigger in each FM-9 GI Style AR-15 Trigger Group gets a self-lubricating Nickel Teflon coating that reinforces the smoothness of the pull.

  • Supremely hard, highly wear-resistant A2 tool steel construction
  • High-grade stainless steel music wire springs included
  • Drop-in fit in standard AR-15 lower receiver
  • Pins not included – save your (.153″ dia.) originals

Drop-In Two-Stage Target Trigger Upgrade

The FM Products FM-9 Match Grade Competition Trigger Group gives you a smooth, consistent, two-stage pull, with a clean break and little-to-no pre- and over-travel. It’s built with a fit, finish, and attention to detail found in very few AR triggers, let alone one at this price-point.

Each FM-9 Match Grade Competition Trigger Group is machined from A2 tool steel (forget about MIM parts!) to precise dimensions, then micro polished to eliminate “creep” during the pull. Finally, the hammer and trigger in each FM-9 Match Grade Competition Trigger Group gets a super-hard, self-lubricating Nickel Boron coating, the finishing touch to ensure the smoothness of the pull. You can put a LOT of rounds down range before this trigger wears out of spec.

  • Hard, hard, hard A2 tool steel hammer, trigger, disconnector
  • Ultra-hard Nickel Boron coating on hammer / trigger
  • High-grade stainless steel music wire springs included
  • Drop-in fit in standard AR-15 lower receiver
  • Pins not included – retain your (.153″ dia.) originals